Discovery 1 & 2 LED Headlight Conversion Bracket

LED Headlight Mounting Brackets for Land Rover Discovery 1 & 2 — 5x7 or 7-Inch Conversion

Off-road use only: These brackets are supplied as mounting components only. The purchaser is responsible for confirming fitment, secure installation and compliance with any applicable vehicle regulations. No representation is made that the completed headlight conversion is approved for public-road use.

These aftermarket 3D-printed brackets are designed to allow the fitment of either 5x7-inch rectangular or 7-inch round LED headlights to Land Rover Discovery 1 and Discovery 2 headlight housings.

Product Features

• Designed for Land Rover Discovery 1 and Discovery 2 headlight housings

• Available for 5x7-inch rectangular or 7-inch round LED headlights

• Supplied as a pair

• 3D printed to order

• Headlights, wiring and screws are not included

Compatibility

• Land Rover Discovery 1

• Land Rover Discovery 2

Please confirm your vehicle, headlight size and intended application before ordering.

Options

• 5x7-inch LED headlight brackets

• 7-inch round LED headlight brackets

Please select the correct option when placing your order.

What Is Included

• 2x LED headlight mounting brackets

Not included: headlights, wiring, screws or installation services.

Installation Notes

• Remove the factory headlight unit.

• Position the bracket within the headlight housing.

• Secure the compatible LED headlight using suitable short 3 mm diameter screws.

• Reinstall the assembly into the vehicle.

• Check the completed installation for secure fitment and correct alignment before use.

Installation should be completed or inspected by a suitably qualified person. The purchaser is responsible for selecting appropriate fasteners for their application.

3D-Printed Finish

This is an aftermarket 3D-printed part. Minor surface variations and visible layer lines may be present as a normal feature of the manufacturing process.

Licensing Notice — CC BY-SA

This product is manufactured from a design licensed under the Creative Commons Attribution-ShareAlike licence.

Any modifications made to the licensed design are shared under the same licence terms.

Important Notice — Off-Road Use Only

This product consists of aftermarket 3D-printed headlight mounting brackets only. Headlights, wiring, fasteners and installation services are not included unless expressly stated otherwise.

These brackets are sold for off-road and competition use only. Lu’s 3D does not represent or warrant that the brackets, or any lighting conversion completed using them, are approved for use on public roads or comply with the roadworthiness, vehicle-modification or lighting requirements applicable in your state, territory or country.

The purchaser is responsible for confirming the suitability of the brackets for their intended application, selecting compatible headlights, using appropriate fasteners and ensuring that the completed installation is secure.

Before use, the brackets, fasteners and headlights must be checked for secure fitment and correct alignment. The installation must be inspected periodically and after off-road use. Discontinue use immediately if any cracking, warping, looseness, excessive vibration or movement of the headlight is identified.

Any use of this product on public roads is at the purchaser’s responsibility and should only occur after the completed conversion has been assessed and approved where required by the relevant authority or an appropriately qualified vehicle certifier.

Nothing in this notice excludes, restricts or modifies any consumer rights or guarantees that cannot lawfully be excluded under the Australian Consumer Law.

Processing Time

This product is made to order. Processing times may vary depending on current order volumes. Please contact us before ordering if you have a time-sensitive requirement.